Installation [10/2022 - ]: Procedure

1. Install the No. 2 multi-media module bracket with the 2 screws.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

1. Install the No. 1 multi-media module bracket with the screw.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

1. Attach the clamp to install the telephone ECU wire (to transceiver).

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Connect the connector.

1. Attach the clamp to install the No. 2 antenna cord sub-assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Connect the 3 connectors.

1. Connect the 2 connectors.
2. Attach the guide to temporarily install the DCM (telematics transceiver) with bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Install in this Direction

3. Connect the 2 connectors.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   	Bolt
   	Connector

4. Install the 2 bolts.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

Refer to PROCEDURE - Step 27

Refer to PROCEDURE - Step 1

Refer to INSTALLATION [12/2021 - ]

HINT: 

After replacing the DCM (telematics transceiver), make sure to perform DCM activation.

Refer to DCM ACTIVATION [10/2022 - ]

1. for Remote Connect Compatible Type:

   HINT: 

   After replacing the DCM (telematics transceiver), make sure to perform code registration (Smart key System (for Start Function)).

   Refer to REGISTRATION [12/2021 - ]