LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> RAV4 Plug-In Hybrid SE >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information (PHEV) >> Hazard Warning Switch >> Removal [06/2020 - 10/2022] >> Procedure

Removal [06/2020 - 10/2022]: Procedure

  1. REMOVE CENTER UPPER INSTRUMENT CLUSTER FINISH PANEL 

    Refer to PROCEDURE - Step 6 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2022]

  2. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET 

    Refer to PROCEDURE - Step 2

  3. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [06/2020 - 12/2021] , or refer to REMOVAL [12/2021 - ]

  4. REMOVE AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 12 [06/2020 - 12/2021] , or refer to PROCEDURE - Step 12 [12/2021 - 10/2022]

  6. REMOVE NAVIGATION ECU WITH BRACKET (w/ Navigation System) 

    Refer to PROCEDURE - Step 5

  7. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY 
    1. Place a hand at the rear side of the center register, detach the hazard warning signal switch assembly claw and push towards the rear of the vehicle.

      HINT: 

      Press the hazard warning signal switch assembly from the top and bottom and detach it.

      GTY905453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Press in this Direction - -
    2. Disconnect the connector.
      GTY907624Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals