DTC B1500-13: Fuel Sender Circuit Open [06/2020 - 10/2022]: Procedure

Refer to INSPECTION [06/2020 - ]

Result

Result: 

NG 

REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [06/2020 - 12/2021]  , or refer to  REMOVAL [12/2021 - 10/2022] 

Result: 

OK 

See step  2

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A-1 (FV) - B-1	Always	Below 1 Ω
   A-2 (FE) - B-2	Always	Below 1 Ω
   A-3 (FS) - B-3	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY. Refer to  REMOVAL [06/2020 - 12/2021]  , or refer to  REMOVAL [12/2021 - 10/2022] 

Result: 

OK 

See step  3

1. Disconnect the N47 fuel suction with pump and gauge tube assembly connector.
2. Disconnect the G18 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N47-3 (FS) - G18-31 (FR)	Always	Below 1 Ω
   N47-2 (FE) - G18-24 (FE&B)	Always	Below 1 Ω
   N47-1 (FV) - G18-14 (FV)	Always	Below 1 Ω
   N47-3 (FS) or G18-31 (FR) - Other terminals and body ground	Always	10 kΩ or higher
   N47-2 (FE) or G18-24 (FE&B) - Other terminals and body ground	Always	10 kΩ or higher
   N47-1 (FV) or G18-14 (FV) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [06/2020 - 10/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR