Inspection [03/2023 - ]: Procedure
- INSPECT CHARGE LID LOCK WITH MOTOR ASSEMBLY
- Check the operation of the charge lid lock with motor assembly.
- Measure the resistance according the value(s) in the table below.
*a Component without harness connected
(Charge Lid Lock With Motor Assembly)*b Push Lifter *c Not pushed (ON) *d Pushed (OFF) Standard Resistance
Tester Connection Condition Specified Condition Result R30-1 (+B) - R30-2 (LDSW) Not pushed (ON) Below 1 Ω Ω R30-1 (+B) - R30-2 (LDSW) Pushed (OFF) 10 kΩ or higher kΩ - If the result is not as specified, replace the charge lid lock with motor assembly.
- Measure the resistance according the value(s) in the table below.
- Check the operation of the charge lid lock with motor assembly.