Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
WARNING:
Refer to the precautions before inspecting high voltage circuit.
Refer to PRECAUTION [12/2022 - ]
NOTE:
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- When disconnecting and reconnecting the auxiliary battery.
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Refer to AUTOMATIC LEARNING CHART [12/2022 - 03/2023] , or refer to AUTOMATIC LEARNING CHART [03/2023 - ]
HINT:
- P0A1B-1F may be output as a result of the malfunction indicated by the DTCs in table below.
- The chart above is listed in inspection order of priority.
- Check DTCs that are output at the same time by following the listed order. (The main cause of the malfunction can be determined without performing unnecessary inspections.)
Malfunction Content System Relevant DTC Communication malfunction Hybrid control system U0110-87 Lost Communication with Drive Motor Control Module "A" Missing Message - P0A1B-1F may be output as a result of the malfunction indicated by the DTCs in table below.