Installation [12/2022 - ]: Procedure
- INSTALL REAR SKID CONTROL SENSOR NOTE:
- Keep the tip of the rear skid control sensor and installation hole free of foreign matter.
- Firmly insert the rear speed sensor body into the rear axle carrier sub-assembly before tightening the bolt.
- After installing the rear speed sensor to the rear axle carrier sub-assembly, make sure that there is no clearance between the rear speed sensor stay and rear axle carrier sub-assembly. Also make sure that no foreign matter is stuck between the parts.
Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
- INSTALL REAR WHEEL
Refer to INSTALLATION [12/2022 - ]
- CHECK FOR SPEED SENSOR SIGNAL
Refer to SIGNAL CHECK [12/2022 - ]