Typical Enabling Conditions
P05DB
| Monitor runs whenever the following DTCs are not stored | C1100 (Case 1): Brake pedal position sensor voltage circuit/open C1100 (Case 2): Brake pedal position sensor invalid data C1103 (Case 1): Brake pedal position sensor voltage circuit/open C1103 (Case 2): Brake pedal position sensor invalid data P057C: Brake pedal position sensor open circuit P057D: Brake pedal position sensor circuit high P057E: Brake pedal position sensor intermittent/erratic P05DD: Brake pedal position sensor circuit open P05DE: Brake pedal position sensor circuit high P05DF: Brake pedal position sensor intermittent/erratic P05E0: Brake pedal position sensor "A"/"B" correlation U025E: Lost communication with BSCM2 (CH1) |
| All of the following conditions are met | A, B, C, D, E, F and G |
| A. Following condition is met | More than 0.22 seconds |
| +BS voltage | 8.5 V or higher |
| B. Up/Downstream communication | Valid |
| C. Both of the following conditions are met | More than 0.198 seconds |
| +BS cut MOS | Valid |
| +BS cut MOS voltage | Higher than 7.4 V |
| D. +BS voltage | 9.5 V or higher |
| E. IGR voltage | Higher than 10 V |
| F. IGP voltage | Higher than 10 V |
| G. +BS cut MOS voltage | Higher than 7.8 V |
P05E0
| Monitor runs whenever the following DTCs are not stored | C1100 (Case 1): Brake pedal position sensor voltage circuit/open C1100 (Case 2): Brake pedal position sensor invalid data C1103 (Case 1): Brake pedal position sensor voltage circuit/open C1103 (Case 2): Brake pedal position sensor invalid data P05DB: Brake pedal position sensor invalid data P057C: Brake pedal position sensor open circuit P057D: Brake pedal position sensor circuit high P057E: Brake pedal position sensor intermittent/erratic P05DD: Brake pedal position sensor circuit open P05DE: Brake pedal position sensor circuit high P05DF: Brake pedal position sensor intermittent/erratic U025E: Lost communication with BSCM2 (CH1) |
| All of the following conditions are met | A, B, C, D, E, F and G |
| A. Following condition is met | More than 0.22 seconds |
| +BS voltage | 8.5 V or higher |
| B. Up/Downstream communication | Valid |
| C. Both of the following conditions are met | More than 0.198 seconds |
| +BS cut MOS | Valid |
| +BS cut MOS voltage | Higher than 7.4 V |
| D. +BS voltage | 9.5 V or higher |
| E. IGR voltage | Higher than 10 V |
| F. IGP voltage | Higher than 10 V |
| G. +BS cut MOS voltage | Higher than 7.8 V |