Removal [12/2022 - 03/2023]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Apply protective tape around the windshield lower outside moulding as shown in the illustration.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

   -

   -

   1. Using a clip remover, disengage the 2 clips as shown in the illustration.

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction (1)

   Remove in this Direction (2)

   1. Using a screwdriver with its tip wrapped with protective tape, disengage the 10 claws as shown in the illustration.
   2. Disengage the guide and remove the windshield lower outside moulding as shown in the illustration

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT: 

Perform the following procedure only when replacement of the No. 1 windshield outside moulding clip is necessary.

Refer to REMOVAL [12/2022 - 03/2023]

HINT: 

Perform the following procedure only when replacement of the No. 1 windshield outside moulding clip is necessary.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Tape

   *b

   Flange

   1. Insert a 4.0 mm (0.157 in.) drill bit into a drill.
   2. Tape the 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

      Standard Measurement

      Area	Measurement	Area	Measurement
      A	5.0 mm (0.197 in.)	-	-

      NOTE:

      Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

   3. Lightly press the drill against the rivets to drill off the rivet flanges, and remove the 5 rivets.
      WARNING:

      Be careful of the drilled rivets, as they may be hot.

      NOTE:

      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
      • Prying the rivets with the drill may damage the rivet installation holes or drill bit.

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Remove the 5 No. 1 windshield outside moulding clips.