LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Prius Plug-In Hybrid SE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) >> Back Door >> Reassembly [12/2022 - ] >> Procedure

Reassembly [12/2022 - ]: Procedure

  1. INSTALL BACK DOOR DAMPER STAY LOWER BRACKET LH (w/ Power Back Door) 
    See step  1
  2. INSTALL BACK DOOR DAMPER STAY LOWER BRACKET RH (w/ Power Back Door) 

    HINT: 

    Use the same procedure as for the LH side.

  3. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET LH (w/ Power Back Door) 
    See step  2
  4. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET RH (w/ Power Back Door) 

    HINT: 

    Use the same procedure as for the LH side.

  5. INSTALL POWER BACK DOOR UNIT ASSEMBLY LH (w/ Power Back Door) 
    See step  3
  6. INSTALL POWER BACK DOOR UNIT ASSEMBLY RH (w/ Power Back Door) 

    HINT: 

    Use the same procedure as for the LH side.

  7. INSTALL BACK DOOR STAY BOLT (w/o Power Back Door) 
    See step  1
  8. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET LH (w/o Power Back Door) 
    See step  2
  9. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET RH (w/o Power Back Door) 

    HINT: 

    Use the same procedure as for the LH side.

  10. INSTALL BACK DOOR STAY ASSEMBLY LH (w/o Power Back Door) 
    See step  3
  11. INSTALL BACK DOOR STAY ASSEMBLY RH (w/o Power Back Door) 

    HINT: 

    Use the same procedure as for the LH side.

  12. INSTALL BACK DOOR PANEL CUSHION 
  13. INSTALL DOOR DUST PROOF SEAL 
  14. INSTALL HOLE PLUG 
  15. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY 
  16. INSTALL TELEVISION REAR CAMERA ASSEMBLY 
  17. INSTALL REAR LIGHT ASSEMBLY 
    Refer to PROCEDURE - Step 1
  18. INSTALL BACK DOOR OUTSIDE GARNISH LOWER MOULDING LH 
  19. INSTALL BACK DOOR OUTSIDE GARNISH LOWER MOULDING RH 
  20. INSTALL BACK DOOR LOWER STOPPER LH 

    Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

  21. INSTALL BACK DOOR LOWER STOPPER RH 

    HINT: 

    Use the same procedure as for the LH side.

  22. INSTALL BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH 
    Refer to PROCEDURE - Step 1
  23. INSTALL POWER BACK DOOR WARNING BUZZER (w/ Power Back Door) 
  24. INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Power Back Door) 

    See step  1

  25. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door) 
  26. INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door) 
  27. INSTALL LUGGAGE COMPARTMENT TRIM COVER 
  28. INSTALL BACK DOOR TRIM BOARD ASSEMBLY 
  29. INSTALL DOOR PULL HANDLE 
  30. INSTALL GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY (w/ Power Back Door) 
  31. INSTALL BACK DOOR SIDE GARNISH LH 
  32. INSTALL BACK DOOR SIDE GARNISH RH 
  33. INSTALL BACK DOOR UPPER TRIM PANEL ASSEMBLY 
  34. INITIALIZE POWER BACK DOOR SYSTEM (w/ Power Back Door) 

    Refer to INITIALIZATION [12/2022 - ] 

  35. INSPECT POWER BACK DOOR SYSTEM (w/ Power Back Door) 
    Refer to OPERATION CHECK [12/2022 - ]
  36. PERFORM CALIBRATION 
    1. w/ Parking Assist Monitor System:

      Refer to CALIBRATION [12/2022 - ]

  37. ADJUST BACK DOOR 
    HINT: 
    When the back door damper stay lower bracket is removed, it is necessary to perform back door position adjustment.
    Refer to ADJUSTMENT [12/2022 - ] 
scientia non olet · About LEMON Manuals