Hybrid System Indicator Malfunction [03/2023 - ]: Procedure

1. Check if CAN communication DTCs are output.

   for HEV Model: Refer to DIAGNOSIS SYSTEM [12/2022 - ]

   for PHEV Model: Refer to DIAGNOSIS SYSTEM [03/2023 - ]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

for HEV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2022 - ]

for PHEV Model: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2023 - ]

Result: 

A 

See step  2

1. Check if hybrid control system DTCs are output.

   Powertrain > Hybrid Control > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO HYBRID CONTROL SYSTEM 

for M20A-FXS: Refer to DIAGNOSTIC TROUBLE CODE CHART [12/2022 - ]

Result: 

A 

See step  3

1. Read the Data List according to the display on the GTS.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   HV/EV System Indicator	Hybrid system indicator value	Min.: -100%, Max.: 511% or Unset	Current hybrid system indicator status	"Unset" is displayed when the vehicle is stopped and the ignition switch is ON (READY).

   Body Electrical > Combination Meter > Data List 

   Tester Display
   HV/EV System Indicator

   OK

   Hybrid system indicator value displayed on the GTS is almost the same as the hybrid system indicator indication.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

GO TO HYBRID CONTROL SYSTEM 

for M20A-FXS: Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2022 - ]

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2022 - ]