Engine Oil Pressure Switch Circuit [12/2022 - ]: Procedure

1. Inspect the engine oil pressure switch assembly.

   Refer to INSPECTION [12/2022 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE ENGINE OIL PRESSURE SWITCH ASSEMBLY. Refer to REMOVAL [12/2022 - ] 

Result: 

OK 

See step  2

1. Disconnect the K19 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C36-1 - K19-20 (S)	Always	Below 1 Ω
   C36-1 or K19-20 (S) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2022 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR