Removal [12/2022 - 03/2023]: Procedure
- REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 2
- DRAIN COOLANT (for Inverter)
Refer to PROCEDURE - Step 1
- DISCONNECT NO. 2 VENTILATION HOSE
Refer to PROCEDURE - Step 2
- REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 2
- REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
Refer to PROCEDURE - Step 2
- REMOVE AIR CLEANER CASE SUB-ASSEMBLY
Refer to PROCEDURE - Step 27
- DISCONNECT ENGINE WIRE
- DISCONNECT OUTLET NO. 1 INVERTER COOLING HOSE NOTE:
Put pieces of cloth into the pipe and disconnected hose or cover the pipe and hose with plastic bags to prevent entry of foreign matter.
- DISCONNECT OUTLET NO. 2 INVERTER COOLING HOSE NOTE:
Put pieces of cloth into the pipe and disconnected hose or cover the pipe and hose with plastic bags to prevent entry of foreign matter.
- REMOVE MOTOR COOLING COOLER