DTC B009E-83: Right Side Restraints Sensor 5 Value of Signal Protection Calculation Incorrect [12/2022 - ]: Procedure

Pre-procedure1

• Turn the ignition switch to ON, and wait for at least 60 seconds.

• Check for DTCs.

  Body Electrical > SRS Airbag > Trouble Codes 

  Result

  Result	Proceed to
  B009E-83 is output	A
  B009E-83 is not output	B

Post-procedure1

• None

Result: 

B 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2022 - ] 

Result: 

A 

See step  2

Pre-procedure1

• Turn the ignition switch off.
• Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.

• Check that the connectors are properly connected to the airbag ECU assembly and side airbag pressure sensor RH.

  OK

  The connectors are properly connected.

  Result

  Proceed to
  OK
  NG

Post-procedure1

• None

Result: 

NG 

CONNECT CONNECTORS PROPERLY 

Result: 

OK 

See step  3

Pre-procedure1

• Interchange the side airbag pressure sensor RH with LH and connect the connectors to them.

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

  *1	Side Airbag Pressure Sensor LH
  *2	Airbag ECU Assembly
  *3	Wire Harness

• Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
• Turn the ignition switch to ON, and wait for at least 60 seconds.

• Clear the DTCs stored in memory.

  Body Electrical > SRS Airbag > Clear DTCs 

  Result

  Proceed to
  NEXT

Post-procedure1

• Turn the ignition switch off.

Result: 

NEXT 

See step  4

Pre-procedure1

• Turn the ignition switch to ON, and wait for at least 60 seconds.

• Check for DTCs.

  Body Electrical > SRS Airbag > Trouble Codes 

  Result

  Result	Proceed to
  B009E-83 is output	A
  B009B-83 is output	B
  B009B-83 and B009E-83 are not output	C

  HINT: 

  Codes other than DTCs B009B-83 and B009E-83 may be output at this time, but they are not related to this check.

Post-procedure1

• Turn the ignition switch off.
• Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
• Return the side airbag pressure sensor LH and RH to their original positions and connect the connectors to them.

Result: 

A 

REPLACE AIRBAG ECU ASSEMBLY. Refer to  REMOVAL [12/2022 - 03/2023]  , or refer to  REMOVAL [03/2023 - ] 

Result: 

B 

REPLACE SIDE AIRBAG PRESSURE SENSOR RH. Refer to  REMOVAL [12/2022 - 03/2023]  , or refer to  REMOVAL [03/2023 - ] 

Result: 

C 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [12/2022 - ]