LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Prius LE >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 2) >> Power Back Door Control Switch >> Inspection [12/2022 - ] >> Procedure

Inspection [12/2022 - ]: Procedure

  1. INSPECT POWER BACK DOOR CONTROL SWITCH 
    1. Check the switch.
      GTY1158335Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Power Back Door Control Switch)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition Result
        K65-5 (CSW) - K65-2 (E) Pushed (ON) Below 1 Ω Ω
        K65-5 (CSW) - K65-2 (E) Not Pushed (OFF) 10 kΩ or higher kΩ

        If the result is not as specified, replace the power back door control switch.

    2. Check the switch illumination.
      1. Apply auxiliary battery voltage to the switch connector and check that the power back door control switch illuminates.

        OK

        Tester Connection Condition Specified Condition
        Auxiliary battery positive (+) → Terminal K65-6 (ILL+)
        Auxiliary battery negative (-) → Terminal K65-1 (ILL-)        		 Always Switch illumination illuminates

        If the result is not as specified, replace the power back door control switch.

scientia non olet · About LEMON Manuals