Inspection [03/2023 - ]: Procedure
- CHARGE LID LOCK WITH MOTOR ASSEMBLY
- Check the operation of the charge lid lock with motor assembly (motor operation).
- Apply auxiliary battery voltage to the charge lid lock with motor assembly connector, and check the operation of the charge lid lock with motor assembly.
*A Shaft Stroke *a Component without harness connected
(Charge Lid Lock With Motor Assembly)*b Shaft OK
Tester Connection Specified Condition R30-4 (B) - Auxiliary battery positive (+)
R30-3 (E) - Auxiliary battery negative (-)Shaft not extended
(Unlock)R30-3 (E) - Auxiliary battery positive (+)
R30-4 (B) - Auxiliary battery negative (-)Shaft extended
(Lock) - If the result is not as specified, replace the charge lid lock with motor assembly.
- Apply auxiliary battery voltage to the charge lid lock with motor assembly connector, and check the operation of the charge lid lock with motor assembly.
- Measure the shaft stroke.
OK
Area Condition Specified Condition *A Lever pulled 23.2 to 39.5 mm (0.913 to 1.56 in.) - If the result is not as specified, replace the charge lid lock with motor assembly.
- Check the operation of the charge lid lock with motor assembly (motor operation).