Removal [03/2023 - ]: Procedure

STEERING WHEEL POSITION

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Lower

Extend

Release the tilt and telescopic lever and fully extend and lower the steering column sub-assembly.

REMOVE NO. 3 STEERING WHEEL LOWER COVER

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and 2 guides to remove the No. 3 steering wheel lower cover as shown in the illustration.

REMOVE NO. 2 STEERING WHEEL LOWER COVER
1. Use the same procedure as for the No. 3 steering wheel lower cover.

REMOVE LOWER STEERING COLUMN COVER

NOTE:

Removing the lower steering column cover in the incorrect order will cause the parts to break.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Push in this direction

Remove the 3 screws.
Push the lower steering column cover and disengage the 2 claws as shown in the illustration to remove the lower steering column cover.

REMOVE UPPER STEERING COLUMN COVER

NOTE:

w/ Driver Monitor Camera:

As there is a possibility of the upper steering column cover cracking, do not apply oil, grease, etc., at the position shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

w/o Driver Monitor Camera:

Remove in this Direction

w/ Driver Monitor Camera:

Remove in this Direction

REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

Remove in this Direction

Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
NOTE:
If the claw is pulled with excessive force, it may break.