Removal [02/2024 - ]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
Refer to PRECAUTION [02/2024 - ]
NOTE:After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to REMOVAL [02/2024 - ]
- REMOVE FRONT DOOR UPPER TRIM COVER LH
Refer to PROCEDURE - Step 3 - REMOVE FRONT DOOR ARMREST COVER SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 4 - REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 5
- REMOVE FRONT DOOR SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 21 - REMOVE SIDE AIRBAG PRESSURE SENSOR LH
- Check that the ignition switch is off.
- Check that the cable is disconnected from the negative (-) auxiliary battery terminal.WARNING:
- Wait at least 60 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
- Disconnect the airbag connector.
HINT:
Refer to How to Connect or Disconnect Airbag Connector:
Refer to HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR [02/2024 - ]
- Remove the side airbag pressure sensor LH as shown in the illustration.NOTE:
If the side airbag pressure sensor assembly LH has been dropped, replace it with a new one.
- Disconnect the airbag connector.