Installation [02/2024 - ]: Procedure

INSTALL PURGE VSV (DUTY VACUUM SWITCHING VALVE)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	No. 1 Fuel Vapor Feed Hose	*2	No. 2 Fuel Vapor Feed Hose
*3	Fuel Vapor Feed Hose Assembly	-	-
*a	Paint Mark	*b	45°
*c	60°	*d	2.0 to 7.0 mm (0.0787 to 0.2756 in.)
*e	Upper Side	-	-
	Install in this Direction	-	-

Install the purge VSV (duty vacuum switching valve).
Connect the No. 1 fuel vapor feed hose to the purge VSV (duty vacuum switching valve) and slide the hose clip to secure it.
NOTE:
Align the hose and the hose clip at the locations shown in the illustration and install them.
Connect the fuel vapor feed hose assembly to the purge VSV (duty vacuum switching valve) and slide the hose clip to secure it.
NOTE:
- Make sure that the tabs of the clip are within the area shown in the illustration.
- Align the hose and the hose clip at the locations shown in the illustration and install them.
Connect the No. 2 fuel vapor feed hose and connector to the purge VSV (duty vacuum switching valve).