LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Land Cruiser Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (2 Of 2) >> Roof Drip Side Finish Moulding >> Removal [02/2024 - ] >> Procedure

Removal [02/2024 - ]: Procedure

  1. REMOVE ROOF RACK ASSEMBLY LH (w/ Roof Rack) 

    Refer to REMOVAL [02/2024 - ]

  2. REMOVE ROOF DRIP SIDE FINISH MOULDING JOINT COVER LH (w/o Roof Rack) 
    1. GTY1255627Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Triangle Mark *b Arrow Mark
      Remove in this Direction (1) Remove in this Direction (2)
      1. Put protective tape around the roof drip side finish moulding joint cover LH.
      2. Lift up the front side of the roof drip side finish moulding joint cover LH and detach the clip as shown in the illustration.
      3. Detach the claw and remove the roof drip side finish moulding joint cover LH as shown in the illustration.
    2. Use the same procedure for all roof drip side finish moulding joint covers LH.
  3. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH 
    1. GTY1221966Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Put protective tape around the center roof drip side finish moulding LH.
      2. Detach the claw and remove the center roof drip side finish moulding LH.
  4. REMOVE CENTER NO. 2 ROOF DRIP SIDE FINISH MOULDING LH 
    1. GTY1226178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Put protective tape around the center No. 2 roof drip side finish moulding LH.
      2. Detach the claw and remove the center No. 2 roof drip side finish moulding LH.
  5. REMOVE ROOF DRIP SIDE FINISH MOULDING LH 
    1. GTY1219948Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Put protective tape around the roof drip side finish moulding LH.
      2. Detach the claw and remove the roof drip side finish moulding LH.
        NOTE:
        • Do not remove the roof drip side finish moulding clip.
        • If a roof drip side finish moulding clip is damaged or falls off, replace it with a new one.
  6. REMOVE REAR ROOF DRIP SIDE FINISH MOULDING LH 
    1. GTY1220651Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Put protective tape around the rear roof drip side finish moulding LH.
      2. Detach the claw and clip and remove the rear roof drip side finish moulding LH.
        NOTE:
        • Do not remove the rear roof drip side finish moulding clip.
        • If a roof drip side finish moulding clip is damaged or falls off, replace it with a new one.
scientia non olet · About LEMON Manuals