Meter Screen not Displayed or Blacked Out [11/2021 - ]: Procedure

1. Turn the ignition switch to OFF.
2. Wait for at least 10 minutes after the combination display turned off.
3. Turn the ignition switch to ON.
4. Make sure that the combination meter assembly operates properly.

   OK

   The combination meter assembly activate normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

USE SIMULATION METHOD TO CHECK 

HINT: 

The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - ]

Result: 

NG 

See step  2

Refer to ON-VEHICLE INSPECTION [11/2021 - ]

Result

Result: 

NG 

CHARGE OR REPLACE THE BATTERY 

Refer to REMOVAL [11/2021 - ]

Result: 

OK 

See step  3

1. Check the connecting condition of the combination meter assembly connector.

   OK

   The connector is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [11/2021 - ]

Result: 

OK 

See step  4

1. Disconnect the F11 combination meter assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   F11-1(+B) - Body ground	IG ON	10 to 16 V
   F11-2(IG) - Body ground	IG ON	10 to 16 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  5

1. Check for DTCs.

   Body Electrical > Combination Meter > Trouble Codes 

   OK

   DTCs (current code) are not output.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2021 - 10/2024] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2024 - ]

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [11/2021 - ]