LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2025 >> Corolla LE >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension System (Rear) - Service Information (2 Of 3) >> REAR TRAILING ARM (w/o Electric Parking Brake) >> Removal [09/2024 - ] >> Procedure

Removal [09/2024 - ]: Procedure

  1. REMOVE REAR WHEEL 

    Refer to REMOVAL [09/2022 - ]

  2. REMOVE FRONT FLOOR COVER LH (for LH Side) 

    Refer to PROCEDURE - Step 4

  3. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for LH Side) 

    Refer to PROCEDURE - Step 9

  4. REMOVE FRONT FLOOR COVER RH (for RH Side) 

    Refer to PROCEDURE - Step 5

  5. REMOVE REAR FLOOR SIDE MEMBER COVER RH (for RH Side) 

    Refer to PROCEDURE - Step 8

  6. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY 
    1. Remove the nut and separate the No. 3 parking brake cable assembly from the rear trailing arm assembly.
      GTY1115195Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. SEPARATE REAR SPEED SENSOR 
    1. Disengage the 2 clamps.
      GTY1115194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and separate the rear speed sensor from the rear trailing arm assembly.
  8. REMOVE REAR STABILIZER LINK ASSEMBLY 

    Refer to REMOVAL [09/2024 - ]

  9. REMOVE REAR TRAILING ARM ASSEMBLY 
    1. Using a transmission jack and a wooden block, support the rear No. 2 suspension arm assembly.
      NOTE:
      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
      • Make sure to perform this operation with the vehicle kept as low as possible.
      GTY1118968Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Wooden Block
      *b Transmission Jack
    2. Remove the 2 bolts and separate the rear trailing arm assembly from the rear axle carrier sub-assembly.
      GTY1115192Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts and rear trailing arm assembly.
      GTY1252117Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. REMOVE REAR SUSPENSION ARM COVER 
    1. Secure the rear trailing arm assembly in a vise using aluminum plates.
      GTY905471Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not overtighten the vise.

    2. Disengage the 4 claws and remove the rear suspension arm cover.
      GTY905469Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE REAR SUSPENSION ARM BRACKET 
    1. Remove the bolt, nut and rear suspension arm bracket from the rear trailing arm assembly.
      GTY905470Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals