ABS Warning Light does not Come ON [01/2019 - 09/2022]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT COMBINATION METER ASSEMBLY
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Perform the Active Test of the combination meter assembly using the Techstream.
Refer to DATA LIST / ACTIVE TEST [01/2019 - 03/2019] , or refer to DATA LIST / ACTIVE TEST [03/2019 - 09/2022]
Body Electrical > Combination Meter > Active Test
Tester Display ABS Warning - Check the combination meter assembly.
OK
The ABS warning light turns on or off in accordance with Techstream operation.
Result
Proceed to OK NG
Result:
OK
REPLACE BRAKE ACTUATOR ASSEMBLY. Refer to REMOVAL [01/2019 - 03/2019] , or refer to REMOVAL [03/2019 - 09/2022]
Result:
NG
INSPECT METER / GAUGE SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - 09/2022]