Registration / Initialization / Learning [12/2022 - ]

HINT: 

If the No. 1 traction battery device box has been replaced, make sure to perform "High Voltage Fuse Accumulated Load History Reset" and then clear the DTCs.

DTC P0A95-63 will be stored again if do not perform "High Voltage Fuse Accumulated Load History Reset".

1. Enter the following menus.

   Powertrain > HV Battery > Utility 

   Tester Display
   High Voltage Fuse Accumulated Load History Reset

2. According to the display on the GTS, perform High Voltage Fuse Accumulated Load History Reset and check that "High Voltage Fuse Accumulated Load History Reset is complete." is displayed.
   NOTE:

   • Performing High Voltage Fuse Accumulated Load History Reset takes approximately 20 to 25 minutes.
   • Make sure to confirm that "High Voltage Fuse Accumulated Load History Reset is complete." is displayed on GTS.
   • If "High Voltage Fuse Accumulated Load History Reset has failed. Do you want to try again?" is displayed on the GTS, perform the procedure again.
3. Turn the ignition switch off.