LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Prius LE >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System - Service Information >> Oil Pan And Oil Level Sensor >> Installation [12/2022 - 03/2023] >> Procedure

Installation [12/2022 - 03/2023]: Procedure

  1. INSTALL ENGINE OIL LEVEL SENSOR 
    1. GTY1153741Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using an 8 mm socket wrench, install the engine oil level sensor to the stiffening crankcase assembly with the 2 bolts.

        Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

      2. Apply a small amount of engine oil to the O-ring of the engine oil level sensor.
      3. Install a new clip to the engine oil level sensor.
      4. Connect the engine oil level sensor connector.
  2. INSTALL OIL PAN SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 10
  3. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5

  4. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6

  5. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  6. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 5

scientia non olet · About LEMON Manuals