LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Prius LE >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Ext) - Service Information >> Rear Light Assembly >> Installation [12/2022 - ] >> Procedure

Installation [12/2022 - ]: Procedure

  1. INSTALL REAR LIGHT ASSEMBLY 
    1. GTY1150668Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Back Window Lower Moulding - -
      *a Incorrect *b Correct
      Protective Tape - -
      1. Pull back the back window lower moulding and secure it with protective tape as shown in the illustration.
        NOTE:

        Be careful not to damage the back window lower moulding.

    2. GTY1154846Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Grommet *b Connector
      *c Bolt *d Nut
      1. Connect the grommet.
      2. Engage the 12 clips.
      3. Connect the connector.
      4. Install the rear light assembly with the 2 bolts and 5 nuts.

        Nut 

        Torque: 4.5 N*m (46 kgf*cm, 40 in.*lbf) 

        Bolt 

        Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf) 

  2. INSTALL BACK DOOR OUTSIDE GARNISH LOWER MOULDING LH 
  3. INSTALL BACK DOOR OUTSIDE GARNISH LOWER MOULDING RH 
  4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY 
  5. INSTALL DOOR PULL HANDLE 
  6. INSTALL GLIDE DOOR INSIDE HANDLE BASE ASSEMBLY (w/ Power Back Door) 
  7. INSTALL BACK DOOR SIDE GARNISH LH 
  8. INSTALL BACK DOOR SIDE GARNISH RH 
  9. INSTALL BACK DOOR UPPER TRIM PANEL ASSEMBLY 
  10. INSPECT POWER BACK DOOR SYSTEM 
    Refer to OPERATION CHECK [12/2022 - ]
scientia non olet · About LEMON Manuals