Power Source Circuit [02/2024 - ]: Procedure

1. Disconnect the stereo component equalizer assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   L38-15 (+B) - Body ground	Ignition switch off	11 to 14 V
   L38-29 (IGP) - Body ground	Ignition switch ON	11 to 14 V

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L38-30 (GND) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [02/2024 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR