LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Land Cruiser First Edition >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Active Noise Control System (6 Speakers) - Diagnostic Codes & Circuit Tests >> ACTIVE NOISE CONTROL SYSTEM (for 6 Speakers) >> DTC B1AAF-71: Front Door Right Speaker Circuit Actuator Stuck [02/2024 - ] >> Procedure

DTC B1AAF-71: Front Door Right Speaker Circuit Actuator Stuck [02/2024 - ]: Procedure

  1. CLEAR DTC 
    1. Clear the DTCs.

      Body Electrical > Active Noise Control > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  2

  2. CHECK FOR DTC 
    1. Check for DTCs.

      Body Electrical > Active Noise Control > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      DTCs are output B

    Result: 

    A 

    USE SIMULATION METHOD TO CHECK 

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2024 - ]

    Result: 

    B 

    See step  3

  3. CHECK HARNESS AND CONNECTOR (STEREO COMPONENT EQUALIZER ASSEMBLY - FRONT NO. 1 SPEAKER ASSEMBLY RH AND FRONT NO. 2 SPEAKER ASSEMBLY RH) 

    Pre-procedure1

    1. Disconnect the L38 stereo component equalizer assembly connector.
    2. Disconnect the G10 front No. 1 speaker assembly RH connector.
    3. Disconnect the E22 front No. 2 speaker assembly RH connector.

      Procedure1

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      L38-12 (FR+) - G10-2 (WF+) Always Below 1 Ω
      L38-27 (FR-) - G10-1 (WF-) Always Below 1 Ω
      L38-12 (FR+) - E22-2 (+TW) Always Below 1 Ω
      L38-27 (FR-) - E22-1 (-TW) Always Below 1 Ω
      L38-12 (FR+) - Body ground Always 10 kΩ or higher
      L38-27 (FR-) - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

      Post-procedure1

    5. None

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

    Result: 

    OK 

    See step  4

  4. INSPECT FRONT NO. 1 SPEAKER ASSEMBLY RH 

    Refer to INSPECTION [02/2024 - ]

    Result

    Proceed to
    OK
    NG

    Result: 

    NG 

    REPLACE FRONT NO. 1 SPEAKER ASSEMBLY RH 

    Refer to REMOVAL [02/2024 - ]

    Result: 

    OK 

    See step  5

  5. CHECK FRONT NO. 2 SPEAKER ASSEMBLY RH 
    1. Replace the front No. 2 speaker assembly RH with a new or known good one.

      HINT: 

      Refer to REMOVAL [02/2024 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. CLEAR DTC 
    1. Clear the DTCs.

      Body Electrical > Active Noise Control > Clear DTCs 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  7

  7. CHECK FOR DTC 
    1. Check for DTCs.

      Body Electrical > Active Noise Control > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      DTCs are output B

    Result: 

    A 

    END (FRONT NO. 2 SPEAKER ASSEMBLY RH IS DEFECTIVE) 

    Result: 

    B 

    REPLACE STEREO COMPONENT EQUALIZER ASSEMBLY 

    Refer to REMOVAL [02/2024 - ]