Caution / Notice / Hint

WARNING:

Be careful of flames.

NOTE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Refer to BEFORE DISCONNECTING BATTERY [02/2024 - ]
When disconnecting and reconnecting the auxiliary battery
HINT:

When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

Refer to AUTOMATIC LEARNING CHART [02/2024 - ]
Before preforming this procedure, check for Meter / Gauge System DTC B1500-13 which is stored if an open or short in the circuit is detected. If DTC B1500-13 is output, perform troubleshooting and repairs as necessary.
Refer to DTC B1500-13: Fuel Sender Circuit Open [02/2024 - ]
When the combination meter assembly is replaced, update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [02/2024 - ]