Removal [02/2024 - ]: Procedure

Refer to PROCEDURE - Step 2

HINT: 

The illustration is an example, so the details may differ.

1. w/o Mudguard:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Screw

   Clip

   1. Using a 4 mm hexagon socket wrench, remove the 3 screws.
   2. Remove the clip.
2. w/ Mudguard, for Type A:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Using a 4 mm hexagon socket wrench, remove the screw.

3. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Screw

   Clip

   1. Put protective tape around the front fender moulding sub-assembly LH.
   2. Using a 4 mm hexagon socket wrench, remove the screw.
   3. Remove the 5 clips.

4. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove in this Direction

   -

   -

   1. Detach the clip and claw and remove the front fender moulding sub-assembly LH as shown in the illustration.