Removal [02/2024 - ]: Procedure

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

WARNING:

Wait at least 60 seconds after disconnecting the cable from the auxiliary negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE REAR DOOR UPPER TRIM COVER LH

Refer to PROCEDURE - Step 3
REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY LH

Refer to PROCEDURE - Step 4
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 5
REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH
Refer to PROCEDURE - Step 11
REMOVE REAR DOOR REAR BELT SEAL LH
Refer to PROCEDURE - Step 13
REMOVE REAR DOOR SERVICE HOLE COVER LH

Refer to PROCEDURE - Step 14
REMOVE REAR DOOR FRAME GARNISH LH
Refer to PROCEDURE - Step 15
REMOVE REAR DOOR GLASS RUN LH
Refer to PROCEDURE - Step 16
REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Refer to PROCEDURE - Step 17
REMOVE REAR DOOR NO. 2 FRAME GARNISH LH
Refer to PROCEDURE - Step 18
REMOVE REAR DOOR QUARTER WINDOW GLASS LH
Refer to PROCEDURE - Step 19
REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Refer to PROCEDURE - Step 21

REMOVE REAR DOOR BELT MOULDING LH

Remove in this Direction

Push in this Direction

Put protective tape around the rear door belt moulding assembly LH.
Detach the claw as shown in the illustration.
Detach the claw and remove the rear door belt moulding assembly LH in the order shown in the illustration.