Removal [11/2022 - 09/2024]: Procedure

Refer to PROCEDURE - Step 20

Refer to PROCEDURE - Step 19

1. Insert a hexagon wrench (4 mm width across flats) into the securing hole of the ribbed belt tensioner assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT: 

   Make sure to fully insert the hexagon wrench (4 mm width across flats).

2. Rotate the ribbed belt tensioner assembly counterclockwise to loosen the tension.
3. Pull the hexagon wrench (4 mm width across flats) as shown in the illustration to secure.
4. Remove the fan and generator V belt from the V-ribbed belt tensioner assembly.