Operation not Accepted Even If Air Conditioning Switch is Operated [09/2022 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR DTC
- Clear the DTC.
Body Electrical > Air Conditioner > Clear DTCs
- Check for DTCs.
Body Electrical > Air Conditioner > Trouble Codes
Result
Result Proceed to B14B2-87 is not output A B14B2-87 is output B
Result:
B
GO TO DTC B14B2-87. Refer to DTC B14B2-87: Lost Communication with Front Panel LIN Missing Message [09/2022 - ]
Result:
A
See step 2
- Clear the DTC.
- CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - AUXILIARY BATTERY)
- Disconnect the I49 air conditioning amplifier assembly connector.
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) - Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition I49-5 (B) - Body ground Ignition switch off 11 to 14 V I49-6 (IG+) - Body ground Ignition switch ON 11 to 14 V Ignition switch off Below 1 V Result
Proceed to OK NG
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
Result:
OK
See step 3
- Disconnect the I49 air conditioning amplifier assembly connector.
- CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
- Disconnect the I49 air conditioning amplifier assembly connector.
*a Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) - Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition I49-17 (GND) - Body ground Always Below 1 Ω Result
Proceed to OK NG
Result:
OK
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY. Refer to REMOVAL [09/2022 - 11/2022] , or refer to REMOVAL [11/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
- Disconnect the I49 air conditioning amplifier assembly connector.