DTC Summary
WARNING: This page is about a different variant/trim than selected.
- MALFUNCTION DESCRIPTION
When the ignition switch is turned from ON (READY) to off, the hybrid vehicle control ECU detects that the high-voltage capacitor inside the inverter with converter assembly is not discharged.
The cause of this malfunction may be one of the following:
Inverter voltage sensor (VH) internal circuit malfunction
- Voltage sensor (VH) malfunction
- Motor generator control ECU (MG ECU) malfunction
- Communication (wire harness) malfunction
High voltage system malfunction
- Inverter with converter assembly malfunction
Shutdown signal circuit malfunction
- Hybrid vehicle control ECU malfunction
- Wire harness malfunction
- Inverter with converter assembly malfunction