Skid Control ECU Communication Stop Mode [04/2020 - 09/2022]: Description
WARNING: This page is about a different variant/trim than selected.
| Detection Item |
Symptom |
Trouble Area |
| Skid Control ECU Communication Stop Mode |
Any of the following conditions are met:
- Communication stop for "Skid Control (ABS/VSC/TRAC)" is indicated on the "Communication Bus Check" screen of the Techstream.
Refer to PROBLEM SYMPTOMS TABLE [04/2020 - 09/2022]
- Communication stop history for "Skid Control (ABS/VSC/TRAC)" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "Skid Control (ABS/VSC/TRAC)" is 6 or more.)
Refer to PROBLEM SYMPTOMS TABLE [04/2020 - 09/2022]
- Communication system DTCs (DTCs that start with U) that correspond to "Skid Control ECU Communication Stop Mode" in "DTC Combination Table" are output.
Refer to DTC COMBINATION TABLE [04/2020 - 09/2022]
|
- Brake booster with master cylinder assembly branch line or connector
- Power source circuit of brake booster with master cylinder assembly
- Brake booster with master cylinder assembly ground circuit
- Brake booster with master cylinder assembly
|