Battery ECU Communication Stop Mode [04/2020 - 09/2022]: Description

WARNING: This page is about a different variant/trim than selected.

Detection Item	Symptom	Trouble Area
Battery ECU Communication Stop Mode	Any of the following conditions are met: Communication stop for "HV Battery" is indicated on the "Communication Bus Check" screen of the Techstream. Refer to PROBLEM SYMPTOMS TABLE [04/2020 - 09/2022] Communication stop history for "HV Battery" is indicated on the "Communication Bus Check (Detail)" screen of the Techstream. (The Lost Communication Time value for "HV Battery" is 6 or more.) Refer to PROBLEM SYMPTOMS TABLE [04/2020 - 09/2022] Communication system DTCs (DTCs that start with U) that correspond to "Battery ECU Communication Stop Mode" in "DTC Combination Table" are output. Refer to DTC COMBINATION TABLE [04/2020 - 09/2022]	Battery ECU assembly branch line or connector Power source circuit of battery ECU assembly Battery ECU assembly ground circuit Battery ECU assembly