Reassembly [01/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSTALL OIL PUMP COVER SUB-ASSEMBLY

Coat the oil pump drive rotor and oil pump driven rotor with engine oil, and place them into the oil pump body with the marks facing the oil pump cover sub-assembly side.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Mark

Install the oil pump cover sub-assembly to the oil pump body with the 5 bolts.

Torque: 8.8 N.m (90 kgf/cm, 78 in.lbf)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL OIL PUMP RELIEF VALVE

*1	Oil Pump Relief Valve Plug
*2	Oil Pump Relief Valve Spring
*3	Oil Pump Relief Valve

Coat the oil pump relief valve with engine oil.

Insert the oil pump relief valve and oil pump relief valve spring into the oil pump body.
Using a 27 mm socket wrench, install the oil pump relief valve plug to the oil pump body.
Torque: 49 N.m (500 kgf/cm, 36 ft.lbf)