Inspection [01/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY WARNING:
- To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the power switch on (IG).
- To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
- Disconnect the engine oil pressure switch assembly connector.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream ON.
- Put the engine in inspection mode (Maintenance Mode).
Powertrain > Hybrid Control > Utility
Tester Display Inspection Mode - Start the engine.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1 - Switch body Idling 10 kΩ or higher Engine stopped Below 1 Ω If the result is not as specified, replace the engine oil pressure switch assembly.
- Connect the engine oil pressure switch assembly connector.
- To prevent injury due to contact with an operating cooling fan, keep your hands and clothing away from the cooling fans when working in the engine compartment with the engine running or the power switch on (IG).