DTC P0010-13: A Camshaft Position Actuator Bank 1 Circuit Open [09/2022 - ]: Description

WARNING: This page is about a different variant/trim than selected.

The Variable Valve Timing (VVT) system consists of the ECM, camshaft timing oil control valve assembly and camshaft timing gear assembly.

The VVT system controls the camshaft timing oil control valve assembly to operate the camshaft timing gear assembly and optimize the intake valve timing according to driving conditions. This control is performed based on the air flow volume, throttle position, engine coolant temperature, etc. Based on signals from each sensor, the ECM controls the position of the camshaft timing control valve assembly to change the relative position of the camshaft, enhance the engine torque and fuel economy and decrease the exhaust gas emissions. Using signals from the camshaft position sensor, the ECM detects the actual valve timing and performs feedback control to optimize the valve timing.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory	Note
P0010-13	A Camshaft Position Actuator Bank 1 Circuit Open	Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic).	Open or short in camshaft timing oil control valve assembly circuit Camshaft timing oil control valve assembly ECM	Comes on	DTC stored	SAE Code: P0010 DTC for Mexico Models: Applies