DTC P0010-13: A Camshaft Position Actuator Bank 1 Circuit Open [04/2020 - 09/2022]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTC after recording the freeze frame data and DTC.

   Powertrain > Engine > Clear DTCs 

5. Turn the power switch off and wait for at least 30 seconds.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Put the engine in Inspection Mode (Maintenance Mode).

   Refer to INSPECTION MODE PROCEDURE [06/2018 - ]

   Powertrain > Hybrid Control > Utility 

   Tester Display
   Inspection Mode

5. Start the engine.
6. Enter the following menus: Powertrain / Engine / Trouble Codes.
7. Read the DTCs.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTC P0010-13 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [01/2019 - ] 

Result: 

B 

See step  3

1. Inspect the camshaft timing oil control valve assembly.

   Refer to INSPECTION [01/2019 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY. Refer to  REMOVAL [01/2019 - ] 

Result: 

OK 

See step  4

1. Disconnect the camshaft timing oil control valve assembly connector.
2. Disconnect the ECM connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   C15-1 - C77-35 (OC1+)	Always	Below 1 Ω
   C15-2 - C77-34 (OC1-)	Always	Below 1 Ω
   C15-1 or C77-35 (OC1+) - Body ground and other terminals	Always	10 kΩ or higher
   C15-2 or C77-34 (OC1-) - Body ground and other terminals	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM. Refer to  REMOVAL [04/2020 - 09/2022] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR