On-Vehicle Inspection [01/2019 - 09/2022]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT CIRCUIT OPENING RELAY ASSEMBLY (C/OPN)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the circuit opening relay assembly (C/OPN).
- Measure the resistance according to the value(s) in the table below.
- INSPECT WATER PUMP RELAY (ENG W/PMP)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the water pump relay (ENG W/PMP).
- Measure the resistance according to the value(s) in the table below.
- INSPECT FUEL OPEN RELAY (FUEL OPN)
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 3 - 5 Auxiliary battery voltage is not applied between terminals 1 and 2 10 kΩ or higher Auxiliary battery voltage is applied between terminals 1 and 2 Below 1 Ω If the result is not as specified, replace the fuel open relay (FUEL OPN).
- Measure the resistance according to the value(s) in the table below.