Inspection [09/2022 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT COMBINATION SWITCH ASSEMBLY
- Inspect the DRIVE MODE switch (for Push Switch Type):
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)Standard Resistance
Tester Connection Condition Specified Condition 6 (DRV) - 5 (E) Pressed Below 50 Ω Not pressed 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the DRIVE MODE switch (except Push Switch Type):
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Combination Switch Assembly)"DRIVE +" Side "DRIVE -" Side Standard Resistance
Tester Connection Condition Specified Condition 7 (SEL) - 5 (E) Pushed and held at "DRIVE +" side Below 50 Ω Released (neutral position) 10 kΩ or higher 6 (E) - 5 (E) Pushed and held at "DRIVE -" side Below 50 Ω Released (neutral position) 10 kΩ or higher If the result is not as specified, replace the combination switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the illumination:
- Apply auxiliary battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.
*a Component without harness connected
(Combination Switch Assembly)Standard
Measurement Condition Specified Condition Auxiliary battery positive (+) → 4 (ILL+) Illuminates Auxiliary battery negative (-) → 1 (ILL-) If the result is not as specified, replace combination switch assembly.
- Apply auxiliary battery voltage between the terminals of the switch and check the illumination condition of the combination switch assembly.
- Inspect the DRIVE MODE switch (for Push Switch Type):