LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2024 >> Corolla LE >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 43 (Fuel System (2ZR-FXE) - Service Information) >> FUEL PUMP (w/ Canister Pump Module) >> Inspection [01/2019 - ] >> Procedure

Inspection [01/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT FUEL PUMP 
    1. Check the resistance.
      GTY896310Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Fuel Pump)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 0.2 to 3.0 Ω

        If the result is not as specified, replace the fuel pump.

    2. Check the operation.
      1. Apply auxiliary battery voltage to both terminals. Check that the fuel pump operates.
        NOTE:
        • Perform this test within 10 seconds to prevent the coil from burning out.
        • Keep the fuel pump as far away from the auxiliary battery as possible.
        • Always switch the voltage on and off at the auxiliary battery side, not the fuel pump side.

        If the fuel pump does not operate, replace the fuel pump.

scientia non olet · About LEMON Manuals