Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during purge valve (purge VSV) removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Gas leaks from exhaust system is repaired | Inspection after repair |
|
Refer to INITIALIZATION [01/2019 - 09/2022] , or refer to INITIALIZATION [09/2022 - ] |
NOTE:
When removing the fuel vapor feed hose, hold the purge valve body securely in place by hand.