Inspection [01/2019 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
- Install a clean hose to the PCV valve (ventilation valve sub-assembly).
- Check the PCV valve (ventilation valve sub-assembly) operation.
- Blow air into the No. 1 ventilation case side, and check that air passes through easily.
*a Hose *b Air No. 1 Ventilation Case Side WARNING:Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health.
If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly).
- Blow air into the intake manifold side, and check that air passes through with difficulty.
*a Hose *b Air Intake Manifold Side WARNING:Do not suck air through the valve.
Petroleum substances inside the valve are hazardous to your health.
If the result is not as specified, replace the PCV valve (ventilation valve sub-assembly).
- Blow air into the No. 1 ventilation case side, and check that air passes through easily.
- Remove the hose from the PCV valve (ventilation valve sub-assembly).