Monitor Description

WARNING: This page is about a different variant/trim than selected.

These DTCs are stored if an open or short in the EGR valve assembly circuit is detected.

Example:

If the EGR1, EGR2, EGR3 or EGR4 terminal output voltage is excessively low, but the step motor is still operating, the ECM determines that there is a short in the EGR valve assembly circuit, illuminate the MIL and stores a DTC.
If the EGR1, EGR2, EGR3 or EGR4 terminal output voltage is excessively low, and the step motor is not operating, the ECM determines that there is an open in the EGR valve assembly circuit, illuminate the MIL and stores a DTC.