Engine Coolant Temperature Receiver Gauge Malfunction [01/2019 - 09/2022]: Procedure

1. Check if CAN communication system DTCs are output.

   Refer to DIAGNOSIS SYSTEM [01/2019 - 04/2020] , or refer to DIAGNOSIS SYSTEM [04/2020 - 09/2022]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM 

Refer to HOW TO PROCEED WITH TROUBLESHOOTING [01/2019 - 09/2022]

Result: 

A 

See step  2

1. Check if SFI system DTCs are output.

   Powertrain > Engine > Trouble Codes 

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO SFI SYSTEM 

Refer to DIAGNOSTIC TROUBLE CODE CHART [01/2019 - 04/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [04/2020 - 09/2022]

Result: 

A 

See step  3

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. Perform the Active Test according to the display on the Techstream.

   Body Electrical > Combination Meter > Active Test 

   Tester Display	Measurement Item	Control Range	Diagnostic Note
   Water Temperature Meter Operation (50C, 122F)	Engine coolant temperature receiver gauge (50°C, 122°F)	ON	See [Display 1]
   Water Temperature Meter Operation (60C, 140F)	Engine coolant temperature receiver gauge (60°C, 140°F)	ON	See [Display 1]
   Water Temperature Meter Operation (70C, 158F)	Engine coolant temperature receiver gauge (70°C, 158°F)	ON	See [Display 1]
   Water Temperature Meter Operation (80C, 176F)	Engine coolant temperature receiver gauge (80°C, 176°F)	ON	See [Display 1]
   Water Temperature Meter Operation (Middle)	Engine coolant temperature receiver gauge (Middle)	ON	See [Display 1]
   Water Temperature Meter Operation (110C, 230F)	Engine coolant temperature receiver gauge (110°C, 230°F)	ON	See [Display 1]
   Water Temperature Meter Operation (120C, 248F)	Engine coolant temperature receiver gauge (120°C, 248°F)	ON	See [Display 1]
   Water Temperature Meter Operation (127C, 260F)	Engine coolant temperature receiver gauge (127°C, 260°F)	ON	See [Display 1]

   1. [Display 1]: Water Temperature Meter Operation 

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Engine Coolant Temperature Receiver Gauge

      HINT: 

      Refer to the following table for the specified engine coolant temperature receiver gauge position for each selected value:

      Tester Display	engine coolant temperature receiver gauge indication
      Water Temperature Meter Operation (50C, 122F)	Between 1 and 2 is indicated
      Water Temperature Meter Operation (60C, 140F)	Between 2 and 3 is indicated
      Water Temperature Meter Operation (70C, 158F)	Between 2 and 3 is indicated
      Water Temperature Meter Operation (80C, 176F)	Between 2 and 3 is indicated
      Water Temperature Meter Operation (Middle)	Approximately 3 is indicated
      Water Temperature Meter Operation (110C, 230F)	Between 4 and 5 is indicated
      Water Temperature Meter Operation (120C, 248F)	Approximately 6 is indicated
      Water Temperature Meter Operation (127C, 260F)	Approximately 7 is indicated

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (50C, 122F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (60C, 140F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (70C, 158F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (80C, 176F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (Middle)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (110C, 230F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (120C, 248F)

   Body Electrical > Combination Meter > Active Test 

   Tester Display
   Water Temperature Meter Operation (127C, 260F)

   OK

   Engine coolant temperature receiver gauge indication is normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ECM 

Refer to REMOVAL [01/2019 - 04/2020] , or refer to REMOVAL [04/2020 - 09/2022]

Result: 

NG 

REPLACE COMBINATION METER ASSEMBLY 

Refer to REMOVAL [01/2019 - 03/2019] , or refer to REMOVAL [03/2019 - 09/2022]