DTC U1000: CAN Communication Failure (Message Registry) [06/2018 - 09/2022]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- CLEAR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / AFS or AFS (Sub) / Trouble Codes.
- Clear the DTCs.
Body Electrical > AFS > Clear DTCs
Body Electrical > AFS (Sub) > Clear DTCs
Result
Proceed to NEXT
Result:
NEXT
See step 2
- CHECK FOR DTC
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / AFS or AFS (Sub) / Trouble Codes.
- Check for DTCs.
Body Electrical > AFS > Trouble Codes
Body Electrical > AFS (Sub) > Trouble Codes
OK
DTC U1000 is not output.
Result
Result Proceed to OK A NG (DTC output from headlight ECU sub-assembly LH) B NG (DTC output from headlight ECU sub-assembly RH) C
Result:
A
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ]
Result:
B
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH. Refer to REMOVAL [06/2018 - 09/2022]
Result:
C
REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH. Refer to REMOVAL [06/2018 - 09/2022]