Removal [03/2019 - 09/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Refer to REMOVAL [03/2019 - 09/2022]

REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the clip from the fuel suction tube with pump and gauge assembly.

Using a screwdriver with its tip wrapped with protective tape, remove the fuel pressure regulator assembly from the fuel suction tube with pump and gauge assembly.

NOTE:

Be careful not to damage or deform the fuel pressure regulator assembly.
If the fuel pressure regulator assembly is damaged or deformed, replace it with a new one.
Pull out the fuel pressure regulator assembly carefully because the O-rings are firmly installed between the fuel pressure regulator assembly and fuel suction tube with pump and gauge assembly.
Do not damage the fuel suction tube with pump and gauge assembly.

*a	Protective Tape

Remove the 2 O-rings from the fuel pressure regulator assembly.

O-ring