Adjustment [01/2019 - 09/2022]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, and 2020 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

SECURE VEHICLE

Fully apply the parking brake and chock a wheel.

WARNING:

Make sure to apply the parking brake and chock a wheel before performing this procedure.
If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE CONSOLE BOX ASSEMBLY
Refer to REMOVAL [01/2019 - 09/2022]

ADJUST SHIFT LEVER POSITION

NOTE:

Before adjusting the floor shift transmission control select cable, check that the shift lever position sensor and shift lever are in N.

Slide the adjuster case cover in the direction shown by the arrow.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adjuster Case
*b	Adjuster Case Cover

Using a precision screwdriver, pull out the lock piece of the adjuster case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adjuster Case
*b	Lock Piece

Push in the lock piece of the adjuster case to lock it.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Adjuster Case
*b	Lock Piece

NOTE:

When pushing in the lock piece of the adjuster case to lock it, remove your hand from the lever shaft.

*1	Floor Shift Transmission Control Select Cable
*a	Lever Shaft

When pushing in the lock piece of the adjuster case to lock it, do not move the lever shaft or floor shift transmission control select cable forward or backward.

Move the adjuster case cover in the direction shown by the arrow.

*a	Adjuster Case
*b	Adjuster Case Cover

NOTE:

If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the cable will not be able to lock, and reliable shift operation will not be possible.

INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [01/2019 - 09/2022]