DTC P2610: ECM / PCM Internal Engine Off Timer Performance [01/2019 - 03/2019]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Corolla, 2021 Toyota Corolla, 2020 Toyota Corolla, and 2019 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

REPLACE ECM

Replace the ECM.

Refer to REMOVAL [01/2019 - 03/2019]

Result

Proceed to
NEXT

Result:

See step 2

CLEAR DTC

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs.
Powertrain > Engine and ECT > Clear DTCs

Turn the ignition switch off and wait for at least 30 seconds.

Result

Proceed to
NEXT

Result:

See step 3

CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.

Read the Pending DTCs.

Powertrain > Engine and ECT > Trouble Codes

HINT:

If no pending DTC is output, the repair has been successfully completed.

Result

Proceed to
NEXT

Result:

END